Intellimute Pro - Cobra 14 BAND XRS 9550G Operating Instructions Manual

Settings
Your Detector
Intro Operation Customer Warranty
Hold 2 IntelliMute Button Rev Level Set
Assistance
Intelli
Secondary Icons
button ag... Mute
desired RPMs Set!
Notice
To Set the IntelliMute Activation Point
Tone
Press and hold
the IntelliMute
Two beeps
button for two
seconds.
Main Icons
Rev your engine to None
the level you wish
to set (recommend
slightly above idle)
and hold revs steady
Intro Operation Customer
Assistance
for two seconds.
At the desired Three beeps
rev level, press
and release the
Secondary Icons
IntelliMute button.
IntelliMute Not Set
NOTE If the unit is unable to sense usable pulses
IntelliMu... within three seconds or if you do not set a rev point
within 20 seconds of beginning these steps, IntelliMute
Notice
will indicate an error and automatically turn Off.
Tone
Intelli...
Four beeps
Mute
One Beep
Off
12 English
IntelliMute Button
Press and release
Voice Visual Display
Set Engine Revs Press IntelliMute
button again at
desired RPMs
None None
Warranty
IntelliMute Set IntelliMute Set!
Voice Visual Display
IntelliMute Not IntelliMute not set
Set, Please Try
Again followed by Please try again
IntelliMute Off IntelliMute Off
Your Detector
Intro Operation Customer Warranty

IntelliMute Pro

Assistance
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2,
Spectre I and Spectre IV when traveling at slower speeds. It is intended for use by
experienced users only.
Secondary Icons
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector's radar detection circuits are turned Off to prevent
detection by RDDs.
Main Icons
Before IntelliMute Pro can be turned On, you must have turned On and Set the
IntelliMute activation point. (See pages 11 through 12.)
Notice
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and Intro
NO alerts will be given at RPMs below the IntelliMute activation point.
Secondary Icons
To Turn IntelliMute Pro On
While no signal Tone
is being detected,
Two beeps
press and hold both
the IntelliMute and
City/Hwy buttons for
four seconds.
To Turn IntelliMute Pro Off
Press and hold both Tone
the IntelliMute and
One beep
City/Hwy buttons for
four seconds.
Operation Customer Warranty
Assistance
IntelliMute Button
IntelliMute Pro On
City/Hwy Button
Press and Hold 4 both
i h
buttons simultaneously
NOTE
The arrow up or down will continue
Notice
to show that engine RPMs are above
or below the user-set value.
Voice Visual Display
IntelliMute Pro i blinks continuously
On in the display after
IntelliMute Pro On
blinks
Voice Visual Display
IntelliMute Pro IntelliMute Pro Off
Off blinks in the display
Nothing Comes Close to a Cobra 13
®