Use - Drying - Electrolux EWW 14791 W User Manual

Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button 8 .
If the door cannot be opened, this means
that the machine is already heating or that the
water level is too high. Do not try to force the
door!
During drying phase the door can be opened
only the first 10 minutes and at the end of
drying (after Anti-Crease phase).
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to O . After a few mi-
nutes the door can be opened (pay atten-
tion to the water level and tempera-
ture!) .
After closing the door, it is necessary to se-
lect the programme and options again and to
press button 8 .

USE - DRYING

Drying only
Caution! The recommended load size is
4 kg for cottons and linen, and 3 kg for
synthetic items.
By pressing Drying Time button it is also
possible to dry up to 6 kg of cotton items
(see the «Drying Programme » table).
Caution! The water tap must be
open and the drain hose must be
positioned in the sink or connected
to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin
speed allowed for the type of laundry in
to cancel a pro-
At the end of the programme
The machine stops automatically. Three
blinking 0.00 appear on the display and the
pilot light of button 8 goes off. Some acoustic
signals sound for a few minutes.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the wa-
ter must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8 .
At the end of the programme, turn the pro-
gramme selector dial to O to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
order to obtain the best drying perform-
ances.
3. Select the drying programme for Cottons
or Synthetic in the Drying sector of the
programme selector dial.
4. If you wish to select an electronic drying,
depress the button 4 until the icon corre-
sponding to the required dryness degree
appears on the display, marked with the
icon .
5. If you wish to select a timed drying, press
button 5 until the time you want appears
on the display (see the «Drying Pro-
gramme» table). Every time you press this
button the drying time increases by 5 mi-
nutes.
Note!
electrolux 11