Forced Operation - Heat Controller Energy Knight B/A-HMC30AS Service Manual

11. Forced Operation

To operate the appliance by force in case that the remote controller is
lost, the forced operation button is on the main unit of the appliance to
operate the appliance in the standard conditions.
• Press the forced operation button, the forced operation is carried out.
• Press the forced operation button once again to stop operation.
In case the power comes on again after power failure on the Forced
Operation position, the operating conditions are automatically set as fol-
lows:
During Forced Operation, the initial mode continues.
Operating mode
Indoor FAN Speed
Setting Temperature 22°C(72°F)
12. AUTO RESTART
In case the power comes on again after a power failure, Auto Restarting
Operation is the function to operate procedures automatically to the pre-
vious operating conditions.
If you want to use this operation. The autorestart button is on the main
unit of the appliance in the standard condition.
• press the auto restart button, to make this function active.
• If you do not want to use this operation, free the auto restart button
once again.
Cooling
Model Room Temp. 24°C(76°F) 21°C(70°F) Room Temp. < 24°C(76°F) Room Temp. < 21°C(70°F)
Cooling Cooling
High High
22°C(72°F)
OPERATION OPERATION OPERATION
OPERATION
Heat pump Model
Healthy Dehumidification
Healthy Dehumidification Rule
23°C(74°F)
- 24 -
FORCED FORCED FORCED
FORCED
Heating
High
24°C(76°F)
AUTO
RESTART
AUTO AUTO
RESTART RESTART