Table of Contents
Advertisement
G
S
E N E R A L
A F E T Y
Read these instructions before installation, operation, and service. Save this manual for future references.
1.
Read and understand this operating manual before trying to install or operate the 54" slant wall fan.
2.
Power supply should be OFF and LOCKED OUT for service of electrical components. Use CAUTION in checking voltage or
other procedures requiring power to be ON.
3.
Never attempt to operate the fan by jumping or otherwise bypassing any safety devices on the unit.
4.
Keep the fan clean. Do not allow debris to collect around motors, belts, pulleys, or bearings.
5.
Use CAUTION in working around the fan's moving parts.
S
T A R T U P A N D
With the fan de-energized, rotate the prop by turning the fan pulley, look for clearance between the prop tip and the
housing. Check all fasteners to ensure they are tight. When satisfied, energize the fan and make note of direction of
rotation. The prop should turn counterclockwise when viewed from inside the house. If the prop is rotating backwards,
refer back to Figure 11.1 and switch the black and red wires as noted after de-energizing the fan. Re-check the operation
and when satisfied the fan is operating properly follow the instructions below.
Write down the date that your fan went into service and follow the maintenance schedule as listed below.
Check the belt, pulleys and the bearings after every two months of service. The belt tensioner should be positioned between
nd
rd
the 2
and the 3
notch, as indicated by the mark on the body of the tensioner. Under tensioning will result in belt slippage,
Over tensioning will lead to premature belt and bearing failure.
The motor and shaft bearings are lubricated at the factory. The motor bearings should never require lubrication over the life of
the fan but the fan shaft bearings should be greased after every two-three months of use using the Zerks on top of the pillow
blocks. Only use a small amount of lithium soap base grease after cleaning the Zerks. Contact your fan distributor for the
proper grease.
When cleaning fans, DO NOT SPRAY bearings, tensioner, or motor directly with a pressure washer as this WILL lead to
premature failure of these components. After cleaning the fan simply wipe these parts with a clean rag to remove dirt and
debris. Failure to follow these instructions will void the warranty on these components.
PNEG 1433
S
T A T E M E N T S
O
P E R A T I O N O F
54" Galvanized Slant Wall Fan Installation Operation Manual
Y
F
O U R
A N
- 12 -
Advertisement
Table of Contents
