DLO HomeDock.HD User Manual page 31

G)
Power and boot-up HomeDock HD
Plug the included AC Power Adapter into the
back of the HomeDock HD Base, and the other
end into any available wall outlet. This will turn
on your HomeDock HD and start the boot-up
process, which may take a few minutes.
o
Connect HomeDock HD to your TV
Connect your HomeDock HD to your TV using the
included RCA Composite Cable. Turn on your TV
and select the correct input for HomeDock HD.
HOMEDOCK HO (BACKI
HOMEDOCK HD [BACKI
~ ~
@@0
AV CABLE [RCA COMPOSITEI
~==~
AC POWER ADAPTER
o
Dock iPod, navigate and enjoy
Dock your iPod, allowing it to pivot back and rest
securely against the support stand. Remove the
thin plastic strip on the back of your HomeOock
HD Remote Control to engage the battery. After
allowing your iPod to initialize, use the Remote
to browse and select your iPod content on TV.
D
@
,
o·
,
I
IMPORTANT: On your iPod, ensure that TV Out under
iPod video settings is set to either "Ask" or "On" to
enjoy the video content of your iPod using HomeOock
HO. For iPod touch in particular, see Viewing the
Video Content of Your iPod touch in your User Manual.
NOTE: These instructions are for connecting
HomeOock HO with the included AV Cable IRCA
Composite!. For the best high-definition performance,
you must use an HOM I cable lavailable separately)
to enable high-definition video output. Also, you
must change the video resolution of HomeOock HO
from Standard to High Definition in the Settings>
Resolution menu. For further instruction and other
connection options, refer to Setting Up HomeDock HD
in your User Manual.