Wired Network Settings - Samsung UE46C User Manual

• Depending on how your network is configured, you may be able to attach your product to your
LAN by connecting the LAN port on the back of your product directly to a network wall outlet
using a LAN cable.
See the diagram below. Note that the wall outlet is attached to a modem or router elsewhere in
your house.
The LAN Port on the Wall
If you have a Dynamic Network, you should use an ADSL modem or router that supports the Dynamic
Host Configuration Protocol (DHCP). Modems and routers that support DHCP automatically provide the
IP address, subnet mask, gateway, and DNS values your product needs to access the Internet so you do
not have to enter them manually. Most home networks are Dynamic Networks.
Some networks require a Static IP address. If your network requires a Static IP address, you must enter
the IP address, subnet mask, gateway, and DNS values manually on your product Cable Setup Screen
when you set up the network connection. To get the IP address, subnet mask, gateway, and DNS values,
contact your Internet Service Provider (ISP).
If you have a Windows computer, you can also get these values through your computer.
― You can use ADSL modems that support DHCP if your network requires a Static IP address.
― ADSL modems that support DHCP also let you use Static IP addresses.
LAN
RJ45
LAN Cable

Wired Network Settings

Set the network connection to use Internet services such as perform software upgrades.
Automatic Network Settings
Connect to the network using a LAN cable.
Make sure a LAN cable is connected first.
How to set up automatically
1
Network Settings screen. Select Start, press E, and then press E again.
Go to the
2
The network test screen appears and verifies the network connection.
When the connection has been verified, the
completed." message appears.
― If the connection process fails, check the LAN port connection.
― If the automatic process cannot find the network connection values or if you want to set the
connection manually, go to the next section, network setup.
Manual Network Settings
Offices may use static IP addresses.
If this is the case, ask the network administrator for the IP address, subnet mask, gateway and DNS server
address. Enter these values manually.
Getting the Network Connection Values
To view the Network connection values on most Windows computers, follow these steps.
1
Right click the Network icon on the bottom right of the screen.
2
In the pop-up menu that appears, click Status.
"Wired network and Internet connection
112