The Washing Results And Drying Results Are Not Satisfactory - Electrolux ESF 66814 User Manual

Malfunction
The appliance does
not drain the water
The anti-flood device
operates
The program does
not start
After the check, switch on the appliance.
The program continues from the point of in-
terruption. If the malfunction occurs again,
contact your Customer Care Centre.
If the display shows an alarm code, not de-
scribed in the chart, contact your Customer
Care Centre.

The washing results and drying results are not satisfactory

Problem
The dishes are not clean.
Limescale particles on the
dishes
Possible cause
The water pressure is too low.
There is a blockage in the sink spi-
got.
The installation of the water drain
hose is not correct. The hose is bent
or squashed.
The appliance door is not closed.
Mains plug is not connected.
The delay start is set.
The fuse has blown out in the
household fuse box
Possible cause
The selected washing program
was not suitable for the type of
load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
The water softener is adjusted
on a wrong level.
The salt container cap is not
closed correctly.
Possible solution
Contact your local water authority.
Clean the sink spigot.
Make sure that the installation is cor-
rect.
Close the water tap and contact
your Customer Care Centre.
Close the door.
Plug-in the appliance to the mains.
• Cancel the delay start.
• Wait until the countdown of the
delay start is completed.
Replace the fuse.
When you contact the Customer Care Cen-
tre you will need to give some details of the
appliance that can be found on the rating
plate (e.g. model number, serial number,
product number). We recommend that you
record these details.
Make sure that the washing
program is suitable for the type
of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with salt
for dishwashers.
Adjust the level of the water
softener.
Ensure that the salt container
cap is correctly closed.
electrolux 15
Possible solution