Irda Infrared Module Connector: J7; Chassis Intrusion Switch Connector: J3 - MSI MS-6380 User Manual

Chapter 2

IrDA Infrared Module Connector: J7

This connector allows you to connect to an IrDA Infrared module. You
must configure the setting through the BIOS setup to use the IR function.

Chassis Intrusion Switch Connector: J3

This connector is connected to a 2-pin chassis switch. If the chassis is
opened, the switch will be short. The system will record this status and show
a warning message on the screen. To clear the warning, you must enter the
BIOS utility and clear the record.
J3
Pin
1
2
3
4
5
2-18
Signal
VCC
NC
IRRX
GND
IRTX
1
J7