Replacing A Memory Module - Lenovo H430 User Manual

Replacing a memory module

Attention: Do not remove the computer cover or attempt any repair
before reading the "Important safety information" in the Safety and
Warranty Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of the
Safety and Warranty Guide or HMM, go to the Support Web site at
http://support.lenovo.com.
To replace a memory module:
1. Remove the computer cover. Refer to "Removing the computer cover".
Note: For this procedure, it helps to lay the computer on its side.
2. Locate the memory module connectors. Refer to "Locating components".
3. Remove the memory module being replaced by opening the retaining clips as
shown.
4. Position the new memory module over the memory connector. Make sure the
notch on the memory aligns correctly with the connector key
system board. Push the memory module straight down into the connector until
the retaining clips close.
on the
37
User Guide