Onboard Parallel Port; Pwr On After Pwr-Fail - Abit BE6-II User Manual

3-28

Onboard Parallel Port:

Sets the I/O address and IRQ of the onboard parallel port. Four options are available:
Disable, 3BCh/IRQ7, 278h/IRQ5 and 378h/IRQ7. Default is 378h/IRQ7.
Parallel Port Mode:
Can be set as ECP, EPP, ECP+EPP, or Normal (SPP) mode. Default is Normal (SPP)
mode.
ECP Mode Use DMA:
When the mode selected for the onboard parallel port is ECP, the DMA channel selected
can be Channel 1 or Channel 3.
EPP Mode Select:
When the mode selected for the onboard parallel port is EPP, two EPP version options
are available: EPP1.7 and EPP1.9.

PWR ON After PWR-Fail:

This setting lets you set the system action after a power failure. Three options are available:
Off - On - Former-Sts. The default setting is Off.
This function has to cooperate with the JP2 setting (see section 2-4).
BE6-II
NOTE
Chapter3