Ide Connectors - Abit AI7 User Manual

2-16 Chapter 2

(12). IDE Connectors

This motherboard provides two IDE ports
to connect up to four IDE drives at Ultra
ATA/100 mode by Ultra ATA/66 ribbon
cables. Each cable has 40-pin 80-conductor
and three connectors, providing two hard
drives connection with motherboard.
Connect the single end (blue connector) at
the longer length of ribbon cable to the IDE
port on motherboard, and the other two
ends (gray and black connector) at the
shorter length of the ribbon cable to the
connectors on hard drives.
If you want to connect two hard drives together through one IDE channel, you must configure the second
drive to Slave mode after the first Master drive. Please refer to the drives' documentation for jumper
settings. The first drive connected to IDE1 is usually referred to as "Primary Master", and the second
drive as "Primary Slave". The first drive connected to IDE2 is referred to as "Secondary Master" and the
second drive as "Secondary Slave".
Keep away from connecting one legacy slow speed drive, like CD-ROM, together with another hard drive
on the same IDE channel; this will drop your integral system performance.
AI7/AI7-G