Setting Ringer Volume; Tone / Pulse Switch (T/P) - Geemarc Jupiter 10 User Manual

SETTING UP
3 - SETTING THE RINGER VOLUME
You can set the desired ringer level by using the ringer Hi / Low switch
located on the base of the unit.

4 - TONE / PULSE SWITCH (T/P)

A switch T/P located under the base allows to set the dialling mode.
The Tone/Pulse switch is factory pre-set to Tone position. In the UK, all
telephone exchanges now use Tone dialing. If your phone does not dial out
it is probably being used from an older private switch board (PBX). In this
case, the Tone/Pulse switch must be moved to Pulse.
For product support and help visit our website at
www.geemarc.com
telephone 01707 384438
or fax 01707 372529
8