Integrated Peripherals - Gigabyte GA-G41MT-S2PT User Manual

Init Display First
Specifies the first initiation of the monitor display from the installed PCI graphics card, PCI Express
graphics card or the onboard VGA.
PCI Sets the PCI graphics card as the first display. (Default)
Onboard Sets the onboard VGA as the first display.
PEG Sets the PCI Express graphics card as the first display.
PAVP Mode
Enables or disables PAVP mode. Enable this function if you wish to playback HDCP contents. PAVP
mode can support increased content protection and robustness requirements for premium content play-
back (e.g. Blu-ray disc).
Disabled Disables this function.
PAVP Lite Mode Specifies the buffer memory size for the encryption of compressed video. (Default)
Paranoid PAVP Reserves 96 MB of system memory during boot. This memory is not seen by
the operating system and not available to any user application. Aero (DWM) in
Windows 7/Vista will always be turned off in this mode.
PAVP Lite Mode
This item is configurable only if the PAVP Mode option is set to PAVP Lite Mode.
Options are: 32MB (default), 48MB, 64MB, 128MB and 256MB.
Paranoid PAVP Mode
This item is configurable only if the PAVP Mode option is set to Paranoid PAVP.
Options are: (32+96)128MB (default), (48+96) Round to 160MB, (64+96)160MB, (128+96)224MB and
(256+96)352MB.
The table below shows the supported features of the PAVP Lite and Paranoid modes.
Feature
Compressed video buffer is encrypted
Hardware 128-bit AES decryption
Protected memory
(96 MB reserved during boot)
2-7

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
On-Chip Secondary PCI IDE
Azalia Codec
Onboard H/W LAN
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
USB 1.0 Controller
USB 2.0 Controller
USB Keyboard Function
USB Mouse Function
USB Storage Function
: Move Enter: Select
F5: Previous Values
On-Chip Secondary PCI IDE
Enables or disables the integrated IDE controller. (Default: Enabled)
Azalia Codec
Enables or disables the onboard audio function. (Default: Auto)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
PAVP Lite PAVP Paranoid
Yes
Yes
No
Integrated Peripherals
[Enabled]
[Auto]
[Enabled]
[Disabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 30 -
Yes
Yes
Yes
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults