Panasonic KX-TVA50 Installation Manual page 40

2.3 Names and Locations
System Components
RUN Indicator
Lights during normal operation; flashes when the system is off-line and cannot receive calls.
ALARM Indicator
Flashes when a system error is detected or while the VPS is preparing to shutdown. Lights when the shutdown
procedure is complete.
RESET Button
Restarts the VPS.
Note
•
Make sure the VPS is not in use before pressing the RESET button.
SHUTDOWN Button
Initiates the shutdown procedure. When the ALARM indicator lights after pressing the SHUTDOWN button,
you may safely turn off the power switch.
Note
•
Make sure the VPS is not in use before pressing the SHUTDOWN button.
LAN Port (Optional for KX-TVA50)
Used to access the VPS over an Ethernet network.
USB Port
Used to access the VPS via USB.
Ground Terminal
Must be connected to a ground source with less than 1 W resistance.
DC IN
Used to supply power to the VPS from the AC Adaptor.
Power Switch
Starts the system and begins the self-test.
SAFETY PRECAUTION: When making any connections or removing the cover, be sure the power
switch is turned off.
Factory-installed Flash Memory Card (KX-TVA50 only)
Stores all system programming and system prompts, and allows up to 4 hours of message recording time.
Hard Disk Drive (KX-TVA200 only)
Stores all system programming and system prompts, and allows up to 1000 hours of message recording time.
Note
•
The actual hard disk drive mounted on your VPS may look different from the ones illustrated in this
manual.
Mode Switch
Used to perform one of several administration/service operations by selecting one of 16 switch positions. After
setting the Mode Switch to the appropriate position, shut down and restart the VPS. Change the position of
the switches by using the tip of a pointed object, such as a pen.
40 Installation Manual Document Version 3.0 2010/06