Inband Signaling; Digit Translation Table Parameters - Panasonic KX-TVA50 Installation Manual

5.2.3 PBX Parameters

Inband Signaling

These parameters are used when the Integration Mode is set to Inband. If the PBX type is set to a KX-T
series system, these parameters will be automatically set. If another type of PBX is used, check the system's
Installation Manual for settings.
Code
(default)
1 Ringback Tone
Busy Tone
2
Reorder Tone
3
DND
4
5 Answer
Forwarded to Voice Mail
(Ringing)
6
Forwarded to Voice Mail
(Busy)
7
Forwarded to Extn.
8
Confirmation Tone
9
Disconnect
#9

Digit Translation Table Parameters

These parameters allow PBXs that have a fixed Follow-on ID sequence to be used with the VPS. For example,
a Follow-on ID sequence of [
• Inter-Digit Timeout
This parameter defines the interval of incoming signals (Follow-on ID) from the PBX to the VPS.
• Translation Table
When the system receives digits within the inter-digit time, it checks them against the input table. If they
are found, the VPS translates the digits according to the table.
132 Installation Manual
Call State
The extension dialed is ringing.
The extension dialed is busy.
An invalid extension number is dialed or the call is
inadvertently connected to another Voice Mail port (also
heard when no DTMF receiver is available to the Voice Mail
extension).
The extension dialed has set the Do Not Disturb feature
(DND).
The extension dialed is answered.
The extension dialed is forwarded to Voice Mail and another
Voice Mail port is able to answer. (This lets the first Voice
Mail port, usually an Auto Attendant, send the call to the
other Voice Mail port.)
The extension dialed is forwarded to Voice Mail and no other
Voice Mail ports are available to accept the call. (This signals
the Voice Mail port, usually Auto Attendant, to let the caller
leave a message.)
The extension dialed is forwarded to another non-Voice Mail
extension.
The Message Waiting Lamp On or Message Waiting Lamp
Off code is dialed successfully.
The caller disconnects. The telephone company must set a
CPC signal to the PBX line for this signal to work for trunk
(CO line) calls.
1001] can be changed to [#61001] by using these parameters.
Sent to the Voice Mail Port When...
Document Version 3.0 2010/06