Table of Contents
Advertisement
3 INSTALL THE HOOD
Place the hood on the brackets and slide left to right
to align with rectangular slots at the top.
• Adjust the installation height by tightening or
loosening the screws "A" at the bottom of the
brackets.
4 SIZE DUCT PIECE
• Hold upper air deflector with duct connector
against the ceiling.
• Measure from the
bottom of the support
to top of the hood
as shown. Reduce
this dimension
by 1" to facilitate
installation. The
duct will cover/
overlap the deflector
and the hood outlets.
• Cut duct piece to
size and slip onto the
bottom of the duct
connector.
• Use duct tape to
secure duct piece
to connector.
Installation Instructions
Screws "B"
To Secure Hood
To Wall
Level and
Height
Adjustment
Screws "A"
Duct
Length
Measure
• Align the hood lower mounting holes with pilot
holes in the wall.
• Using two large flat washers (supplied), install wood
screws or wall fastener screws, loosely, into lower
mounting holes. Do not tighten.
• Level the hood by tightening or loosening the
screws "A" located on the bottom mounting
brackets.
• Tighten lower mounting screws.
• Tighten screws "B" located at the top of the
mounting bracket against the hood to clamp
the position. Do not overtighten screws.
5 INSTALL AIR DEFLECTOR
ASSEMBLY
• Place the assembly over the hood outlet.
• Hold the assembly against the ceiling. The penciled
centerline should show through the slot on the
deflector. Mark the two screw holes on the back of
the assembly.
• Remove the
assembly and
drill 1/8" pilot
holes into
the wall studs.
Length
• Enlarge holes
that did not enter
studs to 3/8" and
tap plastic or metal
anchors into the
holes, flush with
the wall.
• Mount the assembly
onto the hood outlet,
push up against the ceiling
and install the screws provided.
• Use duct tape to seal the connection.
CAUTION:
on the bottom duct flange.
7
Lower
Mounting Screws
Do not use sheet metal screws
Advertisement
Table of Contents
