Options Button; Quick Wash Button - Electrolux EW 1265 F Instruction Booklet

• Drain only
- Press the RESET button once, so as to cause
the DRAIN light
START/PAUSE button.
Important! If you accidentally press the RESET
button more than once, the display will show
three blinking dashes. To cause the washing
machine to drain the water, select any washing
programme by means of the FABRICS button,
then press RESET three times in order to select
the DRAIN position (only the DRAIN light will
remain lit).

6 OPTIONS button

Press this button to select the following options:
• PREWASH: select this option if you wish your
laundry to be prewashed before the main wash
(not available for wool and hand-wash cycle).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
• SUPER RINSE: this option can be selected with all
programmes except the wool and hand wash
programme. The machine performs 4 rinses
instead of 3. This option is recommended for
people who are allergic to detergents, and in areas
where the water is very soft.

7 QUICK WASH button

This button allows you to select the QUICK WASH
function, for laundry that is only slightly soiled (not
for wool and HAND WASH programme).
The washing time will be reduced according to the
type of fabric and the selected temperature.
to light up, then press the
8 Display
The following pieces of information are shown on the
display:
• Three blinking dashes, when a programme is
cancelled by means of the RESET button.
The three blinking dashes will also appear when you
press the ON/OFF button to switch the machine on,
if the previously selected cycle has been erased.
• Duration of washing programme in hours
and minutes, after you have selected a
programme.
While the programme is running (after you have
pressed the START/PAUSE button), the displayed
time value decreases by one unit every minute.
• The washing machine has stopped with water in
the tub, at the end of a programme with the
RINSE HOLD option: this is indicated by a static
zero.
• The washing machine has completed the
programme: this is indicated by a blinking zero.
At the same time, the door locked light goes out.
The zero will reappear when you switch the
washing machine on, unless the previous
programme has been erased by means of the
RESET button.
9