Door Reversal - AEG Electrolux EU 1921 C Installation And Instruction Manual

Door reversal

Before starting work, unplug the appliance. To reverse
the opening direction of the door proceed as follows:
remove the lower hinge (3), pin (1), insert (4) and foot
(2);
unscrew the front left foot and screw it back in on the
opposite side;
remove the two screws which mask the holes for fix-
ing the hinge from the front left hand side;
reassemble the door;
refit the lower hinge (turning it through 180 ), the
threaded insert, the pin and the foot on the opposite
side, as shown in the figure.
Remove the handles, after having removed the screw
cover and refit it on the opposite side. The holes that
are not used must be masked with the plastic plugs
removed.
Attention
After having reversed the opening direction of the
door check that all the screws are properly tight-
ened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the cabinet.
In that case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part in-
volved with a normal hairdrier.
D548
D547
B0646
Fig. 3
5
Fig. 4
4
3
1
2
Fig. 5
5