Related Manuals for AEG Electrolux EU1330I
Summary of Contents for AEG Electrolux EU1330I
- Page 1 I N F O I S T R U Z I O N I P E R L ’ I N S TA L L A Z I O N E E L ’ U S O I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L CONGELATORE EU 1830 I FREEZER...
-
Page 2: Table Of Contents
Contents Important Safety Instructions Instructions for the Instructions for the user installer Technical specifications Cleaning the interior Operation Installation Control panel Positioning Starting-up and temperature regulation Electrical connection NORMAL-SUPER switch Door reversibility Warning light Instructions for totally built-in appiances Quick freezing Freezing of fresh foods and storage of commercially frozen food Ice-cube trays... -
Page 3: Important Safety Instructions
Important Safety Instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. - Page 4 ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction. If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor.
-
Page 5: Use
The freezer is marked with the symbol, which means that the compartment is suitable for freezing fresie food and long-term storage of frozen food. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. -
Page 6: Quick Freezing
Quick freezing Storage of commerclally frozen food Make sure that the products trave been correctly Slide switch (F) towards the right to position «S» packed and stored by the retailer; («SUPER»). Indicator light (E) will then light up. that there is only a very short time between when you purchase the products and when you put them in the freezer;... -
Page 7: Defrosting
Defrosting Frost should be removed from the inside of the compartment with the special plastic scraper provided, whenever the thickness exceeds 4 mm. Do not use metal tools to remove frost so as to avoid seriously damaging the appliance. If a thick layer of ice is formed it will be necessary to carry out complete defrosting as following: 1. -
Page 8: Maintenance
Maintenance Unplug the appliance before carrying out any Periods of non-operation maintenance operation. During periods when the appliance is not used, you Warning should take the following precautions: This appliance contains hydrocarbons in its remove the plug from the wall socket; cooling unit maintenance and recharging remove all food from the appliance;... -
Page 9: Technical Specifications
Technical specifications The technical data is indicated in the rating plate on the left side inside the appliance. Installation lf this appliance featuring magnetic door seals is This appliance complies with EEC directive to replace an older appliance having a spring number, 87/308 of 2/6/87 relative to radio lock (latch) on the door or lid, be sure to make interference suppression. - Page 10 For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. If a refrigerator is fitted into a tall kitchen unit together with the freezer, air intake must be both through the grille fixed to the appliance and through a grille fixed to an opening made in the kitchen unit base, having the minimum dimensions indicated in the diagram.
- Page 11 2. Push the appliance up against the side opposite the door hinge. Fix the appliance with the 4 screws supplied. Fit the hinge cover (D), clipping it into place. D648 3. Press on the seal between the appliance and the kitchen unit.
- Page 12 5. Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in the figure and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. D094 6.