Table of Contents
Advertisement
Starting the Wash Programme
1. Check that the dishes and cutlery are loaded into
the dishwasher in such a manner that the spray
arms are free to rotate.
2. Open the tap fully.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A, or B or
C (see „ Programme Table").
For interference suppression reasons, only
1
operate the programme switch with the dish-
washer switched off. It is also possible that
the automated addition of detergent will be
triggered.
5. Turn the programme selector to the required pro-
gramme (see „ Programme Table").
The selected wash programme starts. The pro-
gramme switch rotates during the wash pro-
gramme and indicates the position that has been
reached in the programme.
1
If a wash programme has been started even
though the tap was closed, turn the pro-
gramme selector to the I position, open the
tap and start the programme again.
Changing/Interrupting the Wash
Programme
Only change or interrupt a wash programme
3
in progress if it is absolutely necessary.
When the appliance is closed again, the air
that has entered is heated rapidly and
expands. This can cause water to escape
onto the floor and possibly trigger the anti-
flood system.
Changing the wash programme
1. Turn the program selector to the I position. Wash
programme stops.
Hot steam can escape when the door is
1
opened. There is a risk of scolding! Open the
door carefully.
2. Open dishwasher door and check whether there is
still detergent in the container. Refill the container
if necessary.
3. Close dishwasher door.
4. Turn the programme switch clockwise to A, or B or
C (see „ Programme Table").
5. Turn the programme selector to the required pro-
gramme (see „Programme Table"). Wash pro-
gramme starts.
Interrupting the wash programme by
opening the door of the dishwasher
Hot steam can escape when the door is
1
opened. There is a risk of scolding! Open the
door carefully.
1. Open the door of the dishwasher. The wash pro-
gramme stops.
2. Shut the door. The wash programme continues.
Switching Off the Dish-
washer
When the wash programme is finished:
1. Turn the program selector to the I position.
Hot steam may escape if the door is opened
1
immediately after the end of the programme.
Therefore:
2. Open the door carefully.
Emptying the Dishwasher
3
•
Hot dishes are sensitive to knocks. The dishes
should therefore be allowed to cool down before
removing them from the appliance.
•
Leave the dishes in the dishwasher for approx. 15
minutes after the end of the programme so that
they dry better and can cool down.
•
Empty the lower rack first, then the upper rack. In
this way you will avoid any water left on the upper
rack dripping onto the dishes in the lower rack and
causing water spots.
Please note, that if your dishwasher is
1
installed under a kitchen worktop, escaping
steam may damage the worktop. Its under-
side must be protectad against rising steam
with aluminium foil as prescribed.
17
Hide quick links:
Advertisement
Table of Contents
