Building Over A Kitchen Unit With Door; Fitting The Hob To The Worktop - Electrolux EHE 682 Instruction Booklet

Building over a kitchen unit with door

Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be hot when in
operation. The recommended solution is shown in
diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.

Fitting the hob to the worktop

Before fitting the hob into the cut out, an adhesive
sealing gasket supplied with the hob must be fitted to
the edge of the cut out. It is essential that no gaps are
left in this seal in order to prevent spillage near the
hob seeping into the cabinet below.
1) Place the sealing gasket all around the edge
of the cut out.
2) Place the hob into the cut out and secure it by
means of the relevant fixing clamps and
screws, as shown in the diagram.
3
60
b
FO 1013
Dimensions are given in mm.
FO 0402
a
a
a) Sealing gasket
15