Electrolux EWW 1230 I Instruction Booklet page 20

Drying only
Warning! Do not exceed the maximum laundry
loads:
- 2.25 kg for linen and cottons
- 1.5.0kg for synthetics.
The water tap must be open and the drain hose
must be positioned in the sink or connected to the
drain pipe.
1. Load the laundry
2. Depress the ON/OFF button
machine on.
3. Select the drying programme
synthetics).
4. Depress the DRYING TIME
time you want appears in the display (for timed
drying).
5. Press the START/PAUSE button
programme.
6. At the end of the cycle, turn the programme
selector dial to RESET X and press the ON/OFF
button again to switch the appliance off.
7. Remove the laundry.
to switch the
(for cotton or
button until the
to start the
20
Automatic washing and drying
(NON-STOP programme)
Warning! For NON-STOP programmes, it is also
essential not to exceed the maximum load sizes of
2.25 kg for cotton and 1.5 kg for synthetics.
Do not use a dosing device/ball when carrying
out a washing & drying programme.
1. Load the laundry.
2. Add detergent and additive.
3. Switch the machine on by depressing the
ON/OFF button .
4. Select the wash programme.
5. Select eventually the required options by means
of the relevant buttons. If possible, do not select
a spin speed lower than that proposed by the
appliance to avoid a too long drying time so
saving energy.
In any case the reduction of the spin speed is
only possible after selecting drying. The lowest
values you can select are the following:
- 900 r.p.m. for cottons and 700 r.p.m. for
synthetics with timed drying
6. Select the drying time or degree of drying.
7. Start the programme by depressing the
START/PAUSE button.
8. At the end of the programme, turn the selector
dial to RESET X and press the ON/OFF button
again to switch the machine off.
9. Remove the laundry.