Dip Switch Configuration - Audiovox MEDIABRIDGE Installation Manual

Multimedia integration kit for select audi and volkswagen vehicles in sat emulation

Hide thumbs Also See for MEDIABRIDGE:

Table of Contents

DIP switch configuration

This setting must be performed for proper functionality of the MediaBridge kit. See pages 18-22

to determine the correct DIP switch setting for your vehicle's specific radio.

The configuration switches located on the MediaBridge module are used to set functionality for various radio

models. Refer to pages 18-22 for correct DIP switch settings. Incorrect dip switch settings may cause the

interface to not work properly or to not operate at all. Disconnect the vehicle harness from the module and

cycle ignition off for 60 seconds after changing the switches then reconnect the module!

MediaBridge module

Table of Contents