Advertisement
Trouble Shooting
Make sure both ends of the cable have a clean cut and are
•
unobstructed. If you need to cut the cable end, use a sharp razor
blade.
Make sure the small screw that secures the cable to the adapter
•
has not been over tightened and damaged the cable. Loosen the
screw using the Allen wrench provided and inspect the cable. If the
cable is crushed, cut off the end of the cable as described above.
To re-attach the cable, slowly tighten the screw in 1/2 turn
increments using the Allen wrench provided. Pull on the cable after
every 1/2 turn until it's secure. Be very careful not to over tighten
the screw or you will damage the cable.
Make sure flash sensor cover is in place on the sensor farthest
•
from the camera (See page 5)
If you still experience a flash firing issue after reviewing the above
•
information, please send the camera system to the SeaLife Service
department for a complete evaluation.
20
Advertisement
