Listen To Radio; Tune To Fm Radio Stations; Program Radio Stations Automatically - Philips MCM1120 User Manual

5
Load a tape with the open side downward
and the full spool to the left, and close the
tape door.
6
Press to start recording.
» Disc play starts automatically from the
beginning of the disc or the selected
section.
• To pause or resume recording, press .
• To stop recording, press
Record from radio to tape
1
Tune to a radio station.
2
Pull to open the tape button cover.
3
Press to open the tape door.
4
Load a tape with the open side downward
and the full spool to the left, and close the
tape door.
5
Press to start recording.
• To pause or resume recording, press .
• To stop recording, press
12 EN

5 Listen to radio

Tune to FM radio stations

•
.
1
2
3
4
To tune to a weak station:
.
Press
reception.
Program radio stations
automatically
•
In FM tuner mode, press PROG for 3 seconds
to activate automatic programming.
» [AUTO] (auto) is displayed.
» The unit stores all the FM radio stations
Note
Make sure that you have connected and fully extended
the supplied FM antenna.
Press TUNER.
Press / on the remote control or
press and hold
for two seconds to tune to a radio station.
When the frequency starts to change,
release the button.
» The FM tuner tunes to a station with
strong reception automatically.
Repeat steps 2-3 to tune to more stations.
/ repeatedly until you find optimal
Note
You can program a maximum of 20 preset radio
stations.
automatically and then broadcasts the first
preset radio station.
/ on the front panel