Super Rinse Button - Electrolux EWS 1020 Instruction Booklet

132990770 GB.qxd 11/02/2004
7 Quick wash button
This option can be used for lightly soiled items (not
for wool, hand wash) in order to obtain a good
washing program in a short time. The washing time
will be reduced according to the type of fabric and
the selected temperature.
8 Rinse hold button
When you choose this option, the machine will not
drain the water of the last rinse, so as not to wrinkle
the laundry. At the end of the programme, the light
of the START/PAUSE button goes off, the pilot lights
and
remain lit, to indicate that the water must be
drained. To empty out water there are 2 possibilities:
• Select programme B (draining): The water is
emptied out without spinning.
• Select programme C or D. Selest the spin speed
by means of the relevant button and then depress
the START/PAUSE button. The water is emptied
out and the laundry is spun at the selected spin
speed.
Attention!
Before choosing the programme B , C or D
the selector dial has to be positioned on «0»
(cancelling).

9 Super rinse button

This option can be selected with all programmes,
except the wool programme and handwash. The
machine will add 2 rinses to the selected program.
This option is recommended for people who are
allergic to detergents and in areas where the water is
very soft.
10 START/PAUSE button
This button has two functions:
Start – Pause.
10:33 Pagina 9
Start
After having selected the required programme,
press this button to start the machine; the
corresponding pilot light stops flashing.
If you have selected the delayed start, the machine
begins its countdown. The duration of the
programme or the delay appears on the display.
Pause
To interrupt a programme which is running, depress
the Start/Pause button: the corresponding pilot light
starts start to flash.
To restart the programme from the point at which it
was interrupted, press the START/PAUSE button
again.
11 Programme progress display
By selecting the wash programme, the pilot lights
corresponding to the various phases making up the
programme come on.
After the machine has started, only the running
phase pilot light stays on. When the programme has
finished, the End pilot light comes on.
End
The END pilot light flashes in the event of
operating problems.
At the same time an alarm code appears on the
display.
1 flash = the machine does not fill
2 flashes = the machine does not empty
4 flashes = the door has not been closed
To eliminate the problem, see paragraph "Something
not working".
If at the end of the programme the pilot light
flashes this means that the drain filter must be
cleaned.
9