Starting A Washing Programme - Electrolux ESF 6135 Instruction Book

Starting a washing programme

1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Setting and starting the programme
Press the On/Off button, the corresponding integrated
indicator light will illuminate. Simultaneously, also the
integrated indicator light corresponding to the "Normal
65°C" programme will illuminate and after about 6
seconds from the pressure of the On/Off button the
programme will start automatically.
If you wish to select another programme, after having
pressed the On/Off button, press within 6 seconds, the
button corresponding to the desired programme. The
integrated indicator light corresponding to the programme
illuminates.
It is possible to change the programme selection simply
pressing the button of another programme within 6
seconds.
Note: it is possible to select a washing programme also
with the door slightly opened.
In this case the start of the programme will occur after the
closure of the door.
a) Press On/Off button.
b) Select a washing programme.
c) Close the door.
The programme will start automatically after the closure of
the door.
5. Interrupting or cancelling a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme in
progress
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point
at which it was interrupted.
b) Press the On/Off button (in this case all the integrated
indicator lights turn off). Press the On/Off button again;
the programme will start from the point at which it was
interrupted.
To cancel a washing programme in
progress
Press simultaneously the programme buttons 2 and 3 until
the integrated indicator light of the running programme
button turns off.
Once the the running programme has been cancelled, only
the On/Off integrated indicator light will remain illuminated
(and eventually the intergrated light of the door handle).
(If a new washing programme will be selected, check that
there is detergent in the detergent dispenser).
6. End of the washing programme
The dishwasher will automatically stop.
The integrated indicator light of the programme just
ended will turn on.
Only the On/Off integrated indicator light will remain on.
Switch off the dishwasher by pressing the On/Off button.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.
7. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
16