Rinse Aid - Electrolux ESF 6135 Instruction Book

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
BR10
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position 6 maximum dosage).
The dose is factory set in
position 4.
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the
indicator (B) becomes clear.
If you are using dishwasher detergent that already contains
rinse aid, it is necessary to deactivate the rinse aid
dispenser in order to avoid a double dosage.
Deactivation/activation of the rinse aid
dispenser
(The dishwasher must be switched off)
Factory setting: rinse aid dispenser activated
1. Press the On/Off button (the corrsponding integrated
indicator light illuminates).
2. Press the programme buttons 2 and 3, the integrated
indicator lights of programme buttons 1, 2 and 3 start
flashing.
BR16
3. Press programme button 2, the integrated indicator lights of
programme buttons 1 and 3 turn off, while the upper
integrated indicator light of programme button 2 goes on
flashing.
At the same time the lower integrated indicator light of
programme button 2 illuminates indicating that the rinse aid
dispenser is active.
4. To deactivate the rinse aid dispenser, press the programme
button 2 again, the lower integrated indicator light of
programme button 2 turns off, indicating that the rinse aid
dispenser has been deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button or wait about 60 seconds after
which the dishwasher will automatically return to setting
mode.
To activate again the rinse aid dispenser follow the above
instructions until the lower integrated indicator light of
programme button 2 illuminates.
BR12
BR11
10