Panasonic Workio DP-C305 Scan/Email Manual page 11

6
Insert the SD Memory Card.
Push the Slot Cover to open it.
Insert the SD Memory Card as illustrated.
(Label side up)
7
Select "SD Card".
Only one storage device can be selected at
a time. When the "SD Card" is selected as
the storage device, the scanned image
cannot be saved to the PCMCIA/PC Card
and Hard Disk Drive at the same time.
If the setting of Function Parameter "84 SD/
PC Card Function" (General Settings > Key
Operator Mode) is set to "No", the
Confirmation screen displays the "Function
not available" error message and beeps.
If you do not touch any key for 3 seconds, or
select "Close" on the Touch Panel Display,
the machine will display the previous screen.
For more details, refer to General Settings
in the Operating Instructions (For Function
Parameters) of provided CD-ROM.
8
Press the Start key.
The scanned image is saved in the following
directory of the SD Memory Card.
Directory: \PRIVATE\MEIGROUP\PCC\DI\IMAGE
The data saved on the SD Memory Card can
be printed by this machine or another DP-
C322*, DP-C262*, DP-C354*, DP-C264*,
DP-C323*, DP-C263*, DP-C213*, DP-C405,
DP-C305, and DP-C265. For more details,
refer to Printing from SD Memory Card/PC
in the Operating Instructions (For Basic
Operations) of provided booklet. When
printing PDF or high-compression PDF data,
install and set up the Memory Card Print
Utility. For details, refer to the Help section of
the Memory Card Print Utility on the
Document Management System CD-ROM.
* Requires optional Printer Controller
Module for printing PDF data.
9
Push the SD Memory Card, and then
remove it.
Do not remove the SD Memory Card while
the Access Indicator is flashing.
10
Close the Slot Cover.
When cancelling the operation, press the Stop key
on the Control Panel, and then select "Yes" on the
Touch Panel Display.
11