Technical Specifications; Installation; Positioning; Electrical Connection - AEG Electrolux ER 6422T Instruction Booklet

Hide thumbs Also See for ER 6422T:
Table of Contents

Advertisement

Technical specifications

The technical data is indicated in the rating plate on the left side inside the appliance.
Height
850
Width
500
Depth
600

Installation

If this model, equipped with a magnetic door
rock, replaces an old appliance with a catch,
ensure that the latter cannot be used before
discarding it to prevent children being trapped
inside.

Positioning

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18°C and +43°C (class T);
+18°C and +38°C (class ST); +16°C and +32°C
(class N); +10°C and +32°C (class SN).
The class of your appliance is shown on its
rating plate.
Ensure that air can circulate freely around the back,
top and bottom of the cabinet.
If the appliance is positioned below an overhanging
kitchen unit, the minimum distance between the top
of the cabinet and the wall unit must be at least 100
mm (Fig.-A).
The ideal solution, however, is the one shown in
Fig.-B (without an overhanging unit).
The appliance can be installed with its sides
touching adjacent kitchen units provided that air can
circulate freely around the back and top. Accurate
levelling is ensured by one or more adjustable feet at
the base of the refrigerator.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
mm
mm
mm
Important
It is essential that the appliance be
connected to an efficient earth tap.
For this purpose the supply cable plug
incorporates a special earth contact. If the
sockets of your domestic wiring system are
not earthed, have the appliance connected
to a separate earth wire by a qualified
electrician in accordance with existing safety
regulations.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
15

Advertisement

Table of Contents
loading

Table of Contents