ADJ AGGRESSOR HEX LED User Instructions page 3

Aggressor HEX LED
Introduction:
The ADJ Aggressor HEX LED is a 6-in-1 LED moon-
flower effect. This fixture is designed for mobile DJ's, clubs, bands,
roller rinks and any arena that requires a compact, light weight, easy
to use unit.
General Operation:
This fixture is designed to operate as a stand
alone sound active unit, there is no need of a controller. It has been
tested and there is no assembly necessary. The Aggressor HEX LED
is ready to be plugged in out of the box, there is no power switch.
Plug the unit in to a matching power outlet or into a power pack.
Light output will be immediate when the unit is powered on. The unit
must receive a sound source to operate normally. Use the sound
sensitivity knob on the rear of the unit to adjust the sound sensitivity.
Turning it clockwise will make it more sensitive to sound, turning it
counter-clockwise will make it less sensitive.
Aggressor HEX LED
Fuse Replacement:
First unplug the power. The fuse holder is
located at the rear of the unit next to the power cord. Using a flat-
head screw driver unscrew the fuse holder. Remove the bad fuse and
replace with a new one.
ADJ Product, LLC - www.adj.com - Aggressor HEX LED Instruction Manual Page 4
Operation
Fuse Replacement
Aggressor HEX LED
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 10 fixtures maximum. After 10 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
Aggressor HEX LED
Trouble Shooting:
Listed below are a few common problems that
you may encounter, with solutions.
No light output from the unit;
1. Be sure the fuse has not blown. The fuse is located on the rear
panel.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may not
activate the unit.
Aggressor HEX LED
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the
internal and external optical lenses must be carried out periodically to
optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Use a brush to wipe down the fan grill.
3. Clean the external optics with glass cleaner and a soft cloth every
20 days.
4. Clean the internal optics with glass cleaner and a soft cloth
every 30-60 days.
5. Always be sure to dry all parts completely before plugging
the unit back in.
Cleaning frequency depends on the environment in which the fix-
ture operates (I.e. smoke, fog residue, dust, dew). In heavy club use
we recommend cleaning on a monthly basis. Periodic cleaning will
ensure longevity, and crisp output.
ADJ Product, LLC - www.adj.com - Aggressor HEX LED Instruction Manual Page 5
Power Cord Daisy Chain
Trouble Shooting
Cleaning