Operation - American DJ WiFly RGBW8C User Instructions

WiFly RGBW8C
There are two ways that the controller can run DMX; connected via
3-pin DMX data cable or using the WiFly DMX signal to eliminate data
cables.
NOTE: To set up properly follow the set up instructions associated
with your WiFly fixture or WiFly TransCeiver.
1. When using 3-pin DMX data cables, the WiFly DMX switch (19)
must be in the OFF position.
2. When using the WiFly DMX signal, the WiFly DMX switch must be
in the ON position. The antenna must be extended and upright.
3. Set the WiFly channel, the WiFly channel must match the set chan-
nel of the fixtures that you are controlling. If the channels are not
the same, you will not be able to control the fixtures. The WiFly
channel can be set from 0-15. If the WiFly controller is transmitting
a WiFly signal, the WiFly indicator (21) will glow red.
ADJ Products, LLC www.adj.com - WiFly RGBW8C
WiFly Set Up WiFly RGBW8C
Note: When the power is switched Off and then back On, the
controller will return to the last operating mode.
Sound Active Mode:
1. Press the SOUND button (7) and the corresponding LED above the
button will light.
2. Use the SOUND SENSITIVITY knob located at the rear to adjust
the sound sensitivity level.
3. Use the faders (10, 11, & 12) to adjust the LED intensity & fade
time. The 1/5 fader (13) cannot be used in this mode.
Chase Mode:
1. Press the CHASE button (2) and the corresponding LED above the
button will light.
2. Press 1 of the 9 COLOR buttons (14) located in the Color/Chases
region to activate a chase. Please see the chase chart on page 13.
3. Once your desired chase program has been selected, use the
faders (10, 11, 12, & 13) to adjust the chase speed, fade time, LED
intensity, and white LEDs.
Auto Mode:
1. Press the AUTO button and the corresponding LED above the but-
ton will light.
2. Use the faders (10, 11, 12, & 13) to adjust the LED intensity, fade
time, and chase speed.
Channel Bank Mode:
1. Press the CHANNEL BANK (9) button and the corresponding LED
above the button will light.
2. Use the faders (10, 11, 12, & 13) to adjust channels 1-4.
3. Press the CHANNEL BANK (9) button again and the corresponding
LED below the button will light.
4. Use the faders (10, 11, 12, & 13) to adjust channels 5-8.
Color Macros Mode:
1. Press the COLOR MACROS (4) button and the corresponding LED
above the button will light.
2. Press any of the 9 color macros (14) or use the fader 1/5 to adjust
the preferable static color, fader 2/6 to adjust fade time, fader 3/7
to control output intensity, and fader 4/8 to control the white LEDs
Page 11 ADJ Products, LLC www.adj.com - WiFly RGBW8C

Operation

Page 12