Huskee 2152374 Owner's Manual page 10

STEP 3: Attach the tongue assembly (5) to the tank assembly (1) using two 1/2" NC x 4-1/2" hex cap bolts (2), two 1/2"
lock washers (3) and two and two 1/2" hex nuts (4). Tighten.
STEP 4: Stand the beam (1) up on end. Two people may be needed for this step to ensure safety. Make sure that the
beam is stable and on a level surface. Remove the pivot pin (3) and clip pin (2) from the tank assembly.Roll
the tongue/ tank assembly into position between the two tabs on the beam (1). Slide the pivot pin (3) through
the aligned holes and lock in place with the clip pin (2)
Page 8
ITEM NO. PART NO. DESCRIPTION
1 40160800 TankAssembly
2 O/L 1/2" NC x 4-1/2 Hex Bolt
3 O/L 1/2" Lock Washer
4 O/L 1/2" NC Hex Nut
5 40127300 Tongue Assembly
ITEM NO. PART NO.
1 401643B0 Beam Assembly
2
3 071022WC
QTY.
1
2
2
2
1
DESCRIPTION
O/L 1/2"-3/4" R Clip Pin
Pivot Pin
QTY
1
1
1