Installation Options; Advance Planning; Installation Preparation - GE ZGU36L6D Installation Instructions Manual

Professional gas cooktops
Table of Contents

Advertisement

These cooktops can be installed in standard
Installation
24" or deeper 25" cabinets.
Options
• In 24" deep cabinets, the front of the
• In 25" deep cabinets, the cooktop will be
Countertop
Level
8-7/16"
3" to Center Line
Refer to "Dimensions and Clearances" for
Advance
appropriate placement and necessary clear-
Planning
ances when planning the installation.
• Cabinetry can not be installed directly above
• We recommend the installation of a vent
• Refer to hood installation instructions for
• Working areas adjacent to the cooktop
cooktop will project approximately 1-7/8"
beyond the front of the countertop.
flush with the front of the countertop.
21-1/4"
High
Back
Low Back
12"
1/2"
of Gas Inlet
1/2"
Cabinet Face - Projecting Control Panel
Cabinet Face - Flush Control Panel
the cooktop.
hood above the cooktop surface.
–The vent hood should be at least 24" deep.
–The vent hood should be the same width as
the cooktop.
–For 48" models, we recommend the vent
hood blower be 1200 CFM.
–For 36" models, we recommend the vent
hood blower be 600 CFM.
height dimensions.
should have 18" minimum clearance
between countertop and cabinet bottom.

Installation Preparation

• The stainless surface of the cooktop will be
1/2" higher than adjacent countertop.
• Cooktop fits flush to rear of cutout, no
additional support is required.
26-5/8"
Front Projects Outward as Shown
From Standard Depth Cabinets.
22-3/4"
23-1/4"
2-1/2"
Front Flush With Cabinets - a Minimum
of 25-3/4" Cabinet Depth Required
• Clearance between cooktop and side wall or
combustible material must be at least 12" on
each side.
• These cooktops require 8" free space below
the countertop.
• If the cooktop is installed in an island:
–Allow 12" min. clearance at the back to
combustible materials.
–Allow 36" min. above the cooking surface to
combustible materials.
• Installation must conform with local codes.
In the absence of local codes, the gas
cooktop must comply with the National Fuel
Gas Code, ANSI Z223.1-1990.
A.G.A. approved.
Professional Gas Cooktops
Cooktop
1/2" Above Adjacent
Countertops.
Cooktop
1/2" Above Adjacent
Countertops.
Flush With Cabinet Front
5

Advertisement

Table of Contents
loading

Table of Contents