Remote Oil Filter; Installation - Universal M3-20A Operator's Manual

REMOTE OIL FILTER
INSTALLATION
This popular accessory is used to relocate the engine's oil fil-
ter from the engine to a more convenient location such as an
engine room bulkhead.
NOTE:
Refer to the ENGINE OIL CHANGE page in this
manual/or instructions on removing the oil filter
To install, simply remove the engine oil filter and thread on
UNIVERSAL's remote oil filter kit as shown.
APPLY A THIN COAT OF CLEAN OIL TO THE O-RING WHEN
INSTALLING THIS KIT. THREAD THE KIT ON, THEN TIGHTEN (BY
HAND) A 314 TURN AFTER THE O-RING CONTACTS THE BASE.
17
Always install this kit with the oil filter facing down as illus-
trated.
Contact your UNIVERSALIWESTERBEKE dealer for more
infonnation.
NOTE:
Westerbeke is not responsible for engine failure due to
incorrect installation a/the Remote Oil Filrer
FASTEN SECURELY TO A BULKHEAO
(SCREWS ARE OWNER SUPPLIED)
APPLY A THIN COAT OF CLEAN OIL TO THE FILTER GASKET
WHEN INSTALLING. ONCE THE FILTER CONTACTS THE BASE,
TIGHTEN IT A 314 TURN.