Filter Cartridge Installation - GE GN1S15CBL (REV. 2) Owners And Installation Manual

About the water filtration system.
Filter Cartridge Installation or Replacement
CAUTION: Never remove the sumps when water
pressure is in the Water Filtration system.
Close the water supply/saddle valve to the filter.
1
(See illustration in the Installation Overview
section for location of the water supply valve.)
Open the filtered water faucet.
Remove the sump, using the sump wrench tool
2
provided, from the filter head by rotating the
sump as shown in the below illustration.
Be careful, the sump may be full of water.
Be sure to keep the large o-ring seal.
If you are replacing a filter cartridge, remove
3
and discard the used filter cartridge.
Be sure the inside of the sump is clean.
4
Thoroughly wash the inside of the sump
with hot, soapy water and rinse.
Remove the wrapper from the new filter
5
cartridge and insert the filter cartridge in the
sump. Some cartridges fit either way, while
others fit only one way. Observe markings on
the cartridge.
NOTE: The Water Filtration system may use two
different types of filter cartridges. Be sure to
install them correctly. Filter I cartridge should
always be placed in the Filter I sump. Filter II
cartridge should always be placed in the Filter II
sump. See page 3 for a complete list of filter
performance characteristics.
For Model GN1S15CBL
(rev. 2)
FXULC (rev. 2) Filter
(600-Gallon Capacity)
Filter – White with
yellow end caps
10
For Model GNSL05CBL
(rev. 2)
FXSLC (rev. 2) Filter
Set
(600-Gallon Capacity)
Filter I – White with no
end caps
Filter II – White with
yellow end caps
Turn sump wrench tool
provided clockwise to
remove sump
INLET
Cartridge
O-ring seal
Sump I
Label
TURN SUMP
TO REMOVE
Filter I
For Models GNSV25CBL,
GNSV30CWW &
GNSV30CCC
FXSVC (rev. 2) Filter Set
(600-Gallon Capacity)
Filter I – White with
green end caps
Filter II – Gray
Sump
Bracket
OUTLET
Head
Sump II
TURN SUMP
TO INSTALL
Filter II