GE Spacemaker WSM2700L Use And Care Manual page 6

How to operate your clothes washer
read the IMPORTANT SA~TY INSTRUCTIONS before operating this appliance.
Add accurately-measured
detergent to empty tub. See pages
11 through 13.
level should be no higher than the
top row of circular holes in the wash
tub. Do not put clothes on top of the
agitator or wind them around it.
For best results, mix large items
with small ones. When washing a
single heavy item, such as a shag
rug or bedspread, add one or two
other pieces to balance the load.
Large items should be no more
than one-half of the total load.
Here is a typical full load:
2 double sheets 2 long-sleeve
2 pair trousers shirts
2 standard
pillowcases
To bleach the load, measure
liquid bleach according to directions
on container. After washer has find
and agitated for several minutes, add
diluted bleach to the wash water.
How to use powdered bleach,
fabric softeners and other laundry
Close lid. Washer will fill and
open. This washer has a Safety Lid
Lock. As a safety measure the lid
will be automatically locked during
the spin portion of each cycle. The
lid will automatically unlock about
30 seconds after the end of the spin
cycle. To open lid during spin cycle,
push Cycle Selector in and wait for
lid lock to release, about 30 seconds,
before opening.
For your personal safety, never
reach into washer while parts are
moving. Always stop washer to
load, unload, add forgotten items
or additional laundry aids.
the risk of fire, electric shock, or injury to persons,
COLD
-@-
Wash temperature
Set the controls
See the Controls Setting Guide on
pages 8 and 9.
Cold rinse will be automatically
provided with all cycles.
Water Level.
LOW: Washer is less than 1/3 full
of clothes.
HIGH: Over 2/3 full of clothes.
Self<leaning lint filter. The lint
filter needs no attention from you.
Lint collected during washing and
rinsing of clothes is automatically
flushed down the drain.
How to soak in the washer
Set Washing Temperature control.
Add detergent or soak agent. Turn
Cycle Selector to desired cycle.
Start the washer. After washer fills
and begins to agitate, push in the
Cycle Selmtor to stop washer. Mow
to soak for as long as desired. After
desired soak, turn to the last Spin.
Pull out the Cycle Selector to
complete the cycle.
/
Water Level
@Push Cycle Selector in and
turn clockwise to your selected
wash cycle.
the cycle. There is a brief pause in
the final spin of each cycle. This is
normal operation for this washer.
Note: If you have selected the Perm
Press or Regular cycle and wish to
change cycle setting after washer
has started, push Cycle Selector in
and wait for washer to stop. Then
reset to the new position. Setting
can be changed at any time during
the Perm Press or Regular cycle.
Delicate cycle
To get the full benefit of the
Delicate Cycle, always set it at
the beginning of the cycle. During
wash, the Delicate Cycle alternate=
between agitation and pauses to
protect delicate clothes.
6
Regular
OFF
OFF