Speaker Settings - Integra DTR-30.1 Instruction Manual

DTR-30.1_En_A.book 44 ページ ２００９年４月９日 木曜日 午後１時３０分
First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the
Audyssey 2EQ™ Room Correction and Speaker Setup
again (see page 47).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
If you've connected your front speakers to the FRONT
L/R and SURR BACK L/R terminal posts for bi-amping,
you must change the "Speaker Type" setting. For hookup
information, see "Bi-amping the Front Speakers" on
page 19.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the
volume.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select "2. Speaker
Setup", and then press [Enter].
The "Speaker Setup" menu appears.
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
3
Use the Up and Down [ ]/[ ] but-
tons to select "1. Speaker Set-
tings", and then press [Enter].
The "Speaker Settings" menu appears.
Speaker Impedance
Speaker Type
Powered Zone 2
Surr Back/Front High
44
2. Speaker Setup
2–1. Speaker Settings
6ohms
Normal
Not Act
Surr Back
4 Use the Up and Down [ ]/[ ] but-
tons to select "Speaker Imped-
ance", and then use the Left and
Right [ ]/[ ] buttons to select:
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Note:
North American models do not support
speakers with an impedance of less
than 6 ohms.
5 Use the Up and Down [ ]/[ ] but-
tons to select "Speaker Type",
and then use the Left and Right
[ ]/[ ] buttons to select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp:Select this if you've con-
nected your front speakers for
bi-amped operation.
Note:
Powered Zone 2 cannot be used if
"Speaker Type" is set to "Bi-Amp".
6 Use the Up and Down [ ]/[ ] but-
tons to select "Surr Back/Front
High", and then use the Left and
Right [ ]/[ ] buttons to select:
Front High:
Select this if you've con-
nected your front high speak-
ers to the SURR BACK L/R
terminal posts.
Surr Back:
Select this if you've con-
nected your surround back
speakers to the SURR BACK
L/R terminal posts.
Note:
• If the "Speaker Type" setting is set to
"Bi-Amp", or Powered Zone 2 is set
to "Not Act", this setting cannot be
selected.
7
Press the [Setup] button.
The setup menu closes.
Powered Zone 2
See "Zone 2" on page 96.
Note:
This procedure can also be performed on the AV receiver by
using its [Setup] button, arrow buttons, and [Enter] button.