Lighting Instructions - Electronic - Lennox ELITE E36ODGNE Care And Operation Instructions Manual

WarninG: iF you do not FoLLoW tHese instructions exactLy, a Fire or expLosion May
resuLt causinG property daMaGe, personaL injury or Loss oF LiFe.
a. When lighting the appliance, follow these instructions
exactly.
B. BeFore operatinG smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHat to do iF you sMeLL Gas
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
. stop! Read the safety information above on this page.
2. Turn remote wall switch to "OFF".
3. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
4. Allow sufficient length of time (minimum 5 minutes) for
any gas in the combustion chamber to escape. If you
still smell gas, STOP! Follow "B" in the safety informa-
tion above on this page. If you do not smell gas, go to the
next step.
. For complete shut-down, turn remote wall switch to "OFF".
0
LiGHtinG instructions — eLectronic
For your saFety read BeFore LiGHtinG
piLot
Lo Hi
to turn oFF Gas to appLiance
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
• Immediately call your gas supplier from a neighbor's
phone.
• If your gas supplier cannot be reached, call the fire
department.
c. Use only your hand to turn the gas control lever. Never
use tools. If the lever will not turn by hand, do not try
to repair it, call a qualified service technician. Force or
attempted repair may result in a fire or an explosion.
d. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been under
water.
LiGHtinG instructions
5. Push the wall mounted "ON/OFF" switch back to the "ON"
position.
- If the burner does not light, replace steps 2 through 5.
- If the burner will not light or stay lit after several tries,
turn the wall mounted "ON/OFF" switch to the "OFF" posi-
tion and call your service technician or gas supplier.
note: Sufficient time must be allowed for air to escape
from lines if the unit is being lit for the first time.
6. Turn HI-LO burner control knob to desired setting and
close control door.
7. If the appliance will not operate, follow the instructions
"To Turn Off Gas To Appliance" and call your service tech-
nician or gas supplier.
to sHut oFF
. Turn off all electrical power to the appliance (remote wall
switch).
2. Turn off all electrical power to the appliances and
remove the batteries if service e is to be performed or
for extended shutdown.