Engine Oil And Oil Strainer - Yamaha Giggle XF50E Owner's Manual

Engine oil<IXE>
To install the spark plug
1. Measure the spark plug gap with a
wire thickness gauge and, if nec-
essary, adjust the gap to specifi-
cation.
Spark plug gap:
0.7 ~ 0.8 mm (0.028 ~ 0.031 in)
2. Clean the surface of the spark plug
gasket and its mating surface, and
then wipe off any grime from the
spark plug threads.
3. Install the spark plug with the spark
plug wrench, and then tighten it to
the specified torque.
Tightening torque:
Spark plug:
13 Nm (1.3 m • kgf, 9.4ft • lbf)
NOTE:
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4~1/2 turn past
finger tight. However, the spark plug
should be tightened to the specified
torque as soon as possible.
PERIODIC MAINTENANCE AND MINOR REPAIR
4. Install the spark plug cap.
5. Install the panel.
6-7

Engine oil and oil strainer

The engine oil level should be checked
before each ride. In addition, the oil must
be changed and the oil strainer cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
To check the engine oil level
1. Place the vehicle
centerstand.
NOTE:
Make sure that the vehicle is positioned
straight up when checking the oil level.
A slight tilt to the side can result in a
false reading.
2. Start the engine, warm it up for sev-
eral minutes, and then turn it off.
EAU17226
EAUT1460
1
2
3
on the
4
5
6
7
8
9