Table of Contents
Advertisement
Maintenance
Cleaning the Pre-motor and Post-motor lters
NOTE: Vax recommends regularly cleaning the lters (depending on level of use) to optimise the
performance of the vacuum cleaner.
NOTE: Do not use any detergents or boiling water to wash the lters (max 40°C).
NOTE: Allow lters to completely dry before replacing back into the machine. We recommend
24hrs to dry completely.
Cleaning the Pre-motor Foam Filter
Remove the dirt container
as previously directed.
Remove the lters as
shown above.
Cleaning the Post-motor HEPA Filter
Storage
IMPORTANT: Always unplug the vacuum cleaner from the electrical outlet and rewind the power
cord as directed before storing.
NOTE: Always store the vacuum cleaner base down.
7
(Keep your Vax as good as new)
The pre-motor foam lter,
may be rinsed in luke
warm water (max 40°C).
Allow to thoroughly air dry
before replacing.
Release the post-motor
cover by pressing in
the catch at the top of
the cover.
NOTE: This is located
at the rear of the vacuum
cleaner.
Clean Cage Filter
Separate the lter assembly by removing the foam lter
from its plastic housing. Tap the foam lter on the inside
of a rubbish bin to remove excess dust and dirt from lter.
The post-motor HEPA lter can be removed and rinsed
in luke warm water (max 40°C). Allow to thoroughly air
dry before replacing (allow 24hrs).
Replace the post-motor HEPA lter back in the case
and return to the vacuum cleaner.
Replacement Filters
Replacement lters are available from your Vax stockist.
Phone VAXCARE or visit www.vax.com.au
Vax Service line:
AU: 1300 361 505
NZ: 0800 800 900
Advertisement
Table of Contents
