Pioneer DVR-550H-K Operating Instructions Manual page 65

Playback
Press to skip to previous/next
PREV NEXT
chapter/title. (During playback
you can also use the front panel
CH +/– buttons.)
During playback, enter a title
REC MODE
number then press ENTER to
AUDIO SUBTITLE ANGLE
skip directly to that title.
PLAY MODE
Press CLEAR to clear a number
CLEAR
entry and start again.
ENTER
(Commercial back/skip) Each
press skips backward/forward
CM CM
BACK SKIP
progressively up to a maximum
of two hours in either direction.
While paused, press and hold
/ /
to start slow-motion playback.
Press repeatedly to change the
playback speed.
While paused, press to advance
a single frame in either
direction.
Playing CDs and WMA/MP3 discs
The table below shows the basic playback
controls for audio CDs
files.
Press to start playback.
PLAY
Press to stop playback.
STOP
Pauses playback, or restarts
PAUSE
playback when paused.
Note
1 If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with
a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected
using the AUDIO (SHIFT + 4) button (see Switching audio channels on page 72).
2 When playing in PBC mode, some playback features, such as search, repeat and programme play are not
available. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc
Navigator (see Using the Disc Navigator with playback-only discs on page 68).
1
, and WMA/MP3
Except WMA: Press to start
scanning. Press again to
increase the scanning speed.
(There are two scan speeds; the
current scan speed is shown
on-screen.)
Press to skip to previous/next
PREV NEXT
track (or folder for WMA/MP3
disc). (During playback you can
also use the front panel CH +/–
buttons.)
During playback, enter a track
REC MODE
number then press ENTER to
AUDIO SUBTITLE ANGLE
skip directly to that track.
PLAY MODE
Press CLEAR to clear a number
CLEAR
entry and start again.
ENTER
Playing Video CD/Super VCDs
The table below shows the basic playback
controls for Video CD/Super VCDs.
Some discs feature Playback Control (PBC
for short) menus. These discs show PBC in
the display when you load them and display
a menu on-screen from where you can select
2
what to watch.
Press to start playback.
PLAY
Video CD only: If RESUME is
displayed on-screen, playback
starts from the place last
stopped.
Press to stop playback.
STOP
Video CD only: You can resume
playback from the same point
by pressing
STOP again to cancel the
resume function.)
07
PLAY. (Press
65
En