Gaskets - Motorola BLE Series Installation And Operation Manual

2 2 2 2 - - - - 4 4 4 4 O v e r v i e w
platform assembly kit (P/N 951941-006-00). The BLE-15A kit contains 15 A platform
assemblies.
Two messenger clamps are cast in the top of the housing and are secured with
5/16 inch × 24 threads-per-inch stainless-steel bolts. The back of the housing also contains two
5/16 inch × 24 threaded holes located on the vertical center-line separated by four inches
center-to-center. Use these holes and the bolts from the messenger clamps for pedestal and
surface-mounting installations.

Gaskets

Each housing is equipped with a recessed woven-wire RF gasket and a silicone-rubber gasket to
provide a seal between the housing base and lid. These gaskets provide efficient ground
continuity, RF shielding, and weather protection. Both gaskets must be in place and in good
condition to ensure proper operation and protection of the station. The weather gasket should be
lightly coated with silicone grease each time the BLE*/* is opened. Replace this gasket if it
becomes damaged or deformed.
B L E * / * I n s t a l l a t i o n a n d O p e r a t i o n M a n u a l