Safety Precautions - Gatekeeper SKC-600DC Owner's Manual

1. Safety Precautions

Installing the SKC-600DC Gate Opener requires installation of standard 110V
electrical wiring. This work should only be performed by a trained technician.
Miswiring could cause personal injury or DEATH. To prevent the risk of
electrocution, be sure to turn off all power to the SKC-600DC until installation
is complete.
Fingers, hands, and loose clothing may be dragged into chain sprockets, please keep

hands, fingers and loose clothing away from chain and rotating sprockets.
 The Gate may move at any time, ensure all persons are clear of the gate when It is
moving to avoid the risk of injury. Do not touch the gate while it is in operation. Do not
attempt to go through the gate while it is still in motion. This operator is intended for
vehicular use only.
 Do not allow children or pets near your gate. Keep the remote controls away from
children. Place controls where they cannot be accessed by reaching through the
gate.
To Avoid electric shock, unplug unit before opening case.

 Make sure the battery inside the operator is charged fully before using.
Before installation, the clutch should be unlocked.

The auto-reverse function must be checked during installation to ensure that the gate

can auto-reverse in the event of obstruction, and it should be inspected regularly.
 The automatic gate opener must be grounded.
Install the gate opener on the inside of the property, DO NOT install it on the outside

of the property where the public has access to it!
 Additional safety equipment such as photoelectric sensors, safety edges, roller
guards and warning signs must be installed to prevent injury.
In the event of power failure, an emergency release key allows you to operate the

gate manually.
Please erase and reset the code after installing the opener.

The gate opener should be installed by a qualified technician; otherwise, serious

personal injury or property damage may occur.
For service, call an experienced technician. Do not in any way modify the components
of the automated system; otherwise serious personal injury or property damage may
occur. We do not accept responsibility for damage or injury resulting from installing of
this operator.