Table of Contents
Advertisement
Procedure to add an additional remote control (learning process):
Press the 'LEARN' button with a screwdriver (see Fig.13), the 'LED2' will flash and turn off,
then press the remote control button which you want to use, the 'LED2' will flash about 2
seconds and then turn off. This indicates that the learning process is complete.
Up to 100 remote controls may be used. Additional RF Remote controls can be obtained
through your dealer. To find a dealer go to www.gatekeeperltd.com/dealers
Erase remote controls: To erase existing remote controls press and hold the 'LEARN' button
until the 'LED2' turns off.
Sliding Gate Operator
CLOSE
OPEN
FORCE
FORCE
SW
LED2
LED1
LEARN
1 2 3 4
ON
Fig.13
Verify open direction: If the gate does not move in the desired direction, then you will need
to reverse the motor operating direction. You can do this by exchanging wires 'D' and 'D' or
by exchanging the two magnet bracket positions, and then insert the wire connector terminal
block.
Set auto-close function (This feature can be selected to make the gate stay open for some
time before it automatically closes, The auto-close time can be adjusted to between 0 and
44 seconds.): Move the first and the second switches of SW (DIP-switch) to ON position
(down) see Fig.13, press remote control button (button 1, button 2 or button 3) that has been
programmed to open the gate, see Verify open direction section. Stop the gate at any
position by pressing the same button, wait for some period of time that you would like the
gate to remain open prior to auto-closing (1~44sec.), this period of time is known as 'auto-
close time'. Close the gate by pressing the same button. Press the button again to stop the
gate or the gate will stop at its closed position automatically if the limit switch is reached.
After this setup is complete, then move the first and the second switches of SW (DIP-switch)
to OFF position (up) immediately. At this point, 'the auto-close function' has been set.
Cancel auto-close function: Move the first and the second switches of SW (DIP-switch) to ON
position (down), press remote control button (button 1, button 2 or button 3) that has been
programmed to open the gate, see Verify open direction section. Stop the gate at any
position by pressing the same button, wait until the gate closes automatically (45 sec.). Press
the same button again to stop the gate or the gate will stop at its closed position
automatically if the limit switch is reached. Then remember to move the first and the second
switches of SW (DIP-switch) to OFF position (up) immediately. Thus 'the auto close function'
has been cancelled.
Set width / auto-close function of pedestrian mode: Pedestrian mode can be used to open
gate about 0.3~2.5 meters for people to pass through.
Advertisement
Table of Contents
