Advertisement
getting stArted
Here is how to set up your A32 in four simple steps:
1 u n p A c k t h e A 3 2
Your A32 is supplied with the following
components:
•
Trigger cable.
•
Mains cable.
If this is missing please contact your supplier.
We recommend you retain the packaging in case
you need to transport the unit at a later date.
2 c o n n e c t s p e A k e r s
The A32 is designed to be connected directly to a
pair of loudspeakers of 8Ω impedance..
•
Connect the LEFT SPEAKER + and – and
RIGHT SPEAKER + and – terminals to the
appropriate terminals on each speaker.
The terminals can accept speaker cables
terminated with spade terminals or bare wires.
For the best sound quality use the upper pair of
loudspeaker terminals. This pair gives the most
direct connection.
To connect bare wires unscrew the terminal, pass
the bare wire through the hole in the terminal
bolt, and clamp the wire in place by screwing the
terminal back down hand tight.
Advice on positioning your speakers
For best results your speakers should be
positioned about 2-3m apart, at least 20cm from
the rear wall and at least 50cm from any side wall.
The tweeter or high frequency unit in the speaker
should be at head height when you are seated,
listening to the speaker.
3 c o n n e c t i n p u t s
•
Connect the A32 to each channel of the
preamplifier or processor using either the
unbalanced RCA input, or the balanced XLR
input, as appropriate.
•
Put the INPUT switch in the appropriate
position for the inputs you are using.
If you are using the RCA inputs use high quality
stereo RCA leads.
If you are using the XLR inputs use balanced XLR
cables.
A 3 2 u s e r g u i d e
4 c o n n e c t p o W e r
Connect the power connector on the back
panel to your power outlet using the mains cable
supplied with the A32.
If this cable is not suitable for your power outlets
please contact your supplier for an alternative
cable.
Note: See Phase , page 4, for information about
getting the best sound from your A32.
WARNING: Before connecting
power check that the required supply
voltage, indicated on the back panel,
corresponds to your local AC supply.
If a different voltage is stated on the type plate do
not connect the amplifier to the mains power, and
seek advice from your dealer.
WARNING: Always disconnect the
A32 from the mains power before
connecting or disconnecting any cables.
To switch on the amplifier
•
Press the Standby button in the Primare logo
on the front panel.
3
Advertisement
