Advertisement
GE T T I N G STA RT ED
1 Unpack the A35.2
Your A35.2 is supplied with:
Mains cable
l
IR/Trigger cable
l
AC Polarity Pen (with batteries)
l
Shorting link
l
If any of these items are missing please contact your
supplier. We recommend you retain the packaging in
case you need to transport the unit at a later date.
2 Connect speakers
The A35.2 is designed to be connected directly to a pair
of loudspeakers of 8Ω impedance.
Connect the left and right loudspeakers to the
l
corresponding terminals on the back panel.
The terminals can accept speaker cables terminated with
bare wires, spade terminals, or banana plugs.
For the best sound quality connect the red wire from each
speaker to the red terminal marked + and the black wire
from each speaker to the black terminal marked –.
To connect bare wires unscrew the terminal, pass the bare
wire through the hole in the terminal bolt, and clamp the
wire in place by screwing the terminal back down hand
tight.
Advice on positioning your speakers
For best results your speakers should be positioned about
2-3m apart, at least 20cm from the rear wall and at least
50cm from any side wall. The tweeter or high frequency
unit in the speaker should be at head height when you are
seated, listening to the speaker.
A35.2 Stereo Amplifier User Guide
3 Connect inputs
Connect the A35.2 to the preamplifier or processor
l
using either the left and right RCA inputs, or the left
and right XLR inputs.
Put the input selector switches in the appropriate
l
positions.
If you are using the RCA inputs use high quality stereo
RCA leads.
If you are using the XLR inputs use balanced XLR cables.
4 Connect power
Plug one end of the mains cable supplied with the
l
A35.2 into the power connector on the back panel,
and connect the other end to a wall socket.
If this cable is not suitable for your power outlets please
contact your supplier for an alternative cable.
Note: See Phase , page 10, for information about getting
the best sound from your A35.2.
WArNiNG: Always disconnect the A35.2
from the mains power before connecting or
disconnecting any cables.
Switch on the A35.2, using the switch on the back
l
panel.
The A35.2 will go into standby mode, indicated by the
front panel light dimly illuminated.
5 Switch on
Press the front panel standby switch, in the middle of
l
the Primare logo.
The indicator light will blink for a few seconds before
staying on.
If no signal is present for 20 minutes the A35.2 will
automatically go into standby to save power.
Automatic standby
By default, if no signal is present for 20 minutes the
A35.2 will automatically go into standby to save power.
to disable automatic standby
Press and hold down the front panel button for a few
l
seconds, and release once the indicator light has
flashed two times and become steadily illuminated.
to re-enable automatic standby
Turn the A35.2 off and then on again using the switch
l
on the back panel.
7
Advertisement
