Using the Linear Imager (DT-X7M10U)
1. After turning on the power, position the reader port close to a bar code and then press
the Trigger key.
2. The LED emits light and scans the bar code. When scanning is completed normally,
Indicator 2 displays a green light and a buzzer sounds.
Important!
•
If you are unable to scan a bar code, try changing the angle at which the
Handheld Terminal is held or distance between the reader port and the bar
code, and then try scanning again.
•
This Handheld Terminal is capable of scanning bar codes at a distance of
about 60-300 mm (2
is possible may vary according to the bar code symbology.
Warning!
■ Never look directly into the LED light.
•
This product scans using LED light. Never look directly into the LED light
or shine the LED light into the eyes.
About the Class 1 LED Label
•
This label identifi es the Handheld Terminal as a Class 1 LED product under
IEC60825-1 (ed.1.2)
6
13
/
"-11
/
"). Furthermore, the distance at which scanning
16
16
E-35