Starting The Engine - Husqvarna RZ46215 Operator's Manual

Starting the Engine

1. Sit on the seat.
2. Raise the mower deck by pushing the release button on
the top of the lifting lever. Pull the lifting lever backward to
the locked (transport) position.
3. Activate the park brake by pushing the release button in
and pulling the lever fully upwards.
4. Disengage the mower blades by pressing the blade
switch downwards.
OPERATION
5. Move the steering controls outward to the locked (outer)
neutral position.
6. Move the throttle lever to the full throttle position.
NOTE: There is a detent at the full throttle position to aid in
setting the control.
7. If the engine is cold, pull the choke control up.
8. Press in and turn the ignition key to the start position.
9. When the engine starts, immediately release the ignition
key back to the run position. Push the choke control in
gradually when the engine has started.
10. Set the engine speed with the throttle. Allow the engine to
run at a moderate speed, approximately mid throttle, for a
short time before use.
11. USE FULL THROTTLE WHEN MOWING.
IMPORTANT INFORMATION Do not run the starter for
more than 5 seconds each time. If the engine does not
start, wait approximately 10 seconds before retrying.
17