Sd Card Slot Troubleshooting; Procedure 1 Check On Windows Xp Tablet Pc Edition; Procedure 2 Connector Check And Replacement Check - Toshiba Tecra M4 Maintenance Manual

2 Troubleshooting

2.15 SD Card Slot Troubleshooting

To check if the SD card slot is good or no good, follow the troubleshooting procedures below
as instructed.
Procedure 1: Check on Windows XP Tablet PC Edition
Procedure 2: Connector Check and Replacement Check
Procedure 1 Check on Windows XP Tablet PC Edition
Insert an SD card into the slot. Check if the installed Windows XP Tablet PC Edition
recognizes automatically the SD card and the data in the SD card can be read.
If the card is not recognized or data are not read, go to Procedure 2.
Procedure 2 Connector Check and Replacement Check
The SD card is connected to the connector IS2130 of the connector board.
Check 1 The SD card and the System board may be disconnected. Make sure the SD card is
firmly inserted to the IS2130 of the System board. If the SD card is still not
functioning properly, perform Check 2.
Check 2 The SD card may be faulty. Replace it with a new one following the step in
Chapter 4. If the problem continues, perform Check 3.
Check 3 The System board may be faulty. Replace it with a new one following the step in
Chapter 4.
2-52 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)

2.15 SD Card Slot Troubleshooting